Robust and user-friendly washing machine for inside cleaning of cylindrical and rectangular containers with brushes and simultaneous spraying with solvent, conductive brushes with type examination according to ATEX → no nitrogen inerting required
Very good inside cleaning of cylindrical containers with a centrifugal folding brush.
Inside cleaning of rectangular containers by a centrifugal brush with long bristles; by pressing a button on a rapid-action coupling, the operator can easily exchange the brush for a centrifugal folding brush
Spraying system for washing with circulated solvent and rinsing with clean solvent.
The brush is lowered into the container, and the upper container opening closed by the machine lid, by means of a pneumatic lifting frame
Position sensor for the lid; spraying and brush rotation do not begin until the lid rests on the container
Washing solvent in separate container, level switch for filling and draining
Dirt resistant diaphragm pump as washing pump, separate pump for rinsing, pneumatic diaphragm pump for draining
Filter with removable basket for protecting the evacuation pump and the solvent tank
Flow monitor; the brush rotation does not start until solvent has been sprayed on the container to prevent dry friction
Automatic washing program: washing – draining – rinsing – internal air extraction; program steps can be selected individually
Explosion protection according to ATEX, category 1 (with type examination) for zone 0 inside, category 2 for zone 1 outside
Centrifugal folding brush with active, reinforced contact pressure and much higher driving power, removes even very difficult residues
3D cleaning of rectangular containers with brushes rotating around 2 axes with variable speed and angle, better cleaning of inside container surfaces that are hard to reach for a conventional brush, such as corners, lid and floor
Outlet cleaning system, manual or automatic
Floor pan for the working area under the lifting frame
Pneumatic lifting platform; the suction hose can be connected at a user-friendly height
Pneumatic tilting of the machine (with the pneumatic lifting platform), better draining of containers with unfavorable floor/outlet geometry
Electric clamping device
Internal air extraction system, optionally with warm air drying for nonvolatile solvents
Brush housing in the lid, reduced emissions during internal air extraction and drying
External air extraction system, supplements/replaces the air extraction in the room/at the workplace
Solvent concentration measuring and regulating system for connection to an exhaust air cleaning system
like model ROBUS, but with the following differences:
Suitable for water-based/alkaline media
Heating of the washing agent, heat insulation of the washing agent container
Rinsing with water
Explosion protection that is adapted to the washing agent with the washed-off contamination and to the requirements of the installation site
Brush with stainless steel bristles
The folding brush is not pressed against the container‘s lateral area just by centrifugal force but also by the driving torque of the brush shaft. The contact pressure on the bottom will also be increased.
The execution of the centrifugal force folding brush with stainless steel bristles can improve the washing result particularly with rough inner surfaces. This can be tested during trials in our show room. NOT suitable for aluminium containers or containers with smooth surfaces (surfaces will be roughed up by the stainless steel bristles).